Recluse Posted October 18, 2011 Report Posted October 18, 2011 (edited) I have no experience with Siemens and have set up a training station to teach myself. I was able to address and program some analog and digital cards but could not drive the digital out due to the BASP being active. I have an S5 135U with a 928B in the slot 11 (Second slot from the left). At this time there are no other cards in the rack and I have an empty CPU. I can do a cold start and put it in RUN mode but still can not get rid of the BASP. There are no critical errors listed in the ISTACK. Any suggestions? Thank you. Edited October 18, 2011 by Recluse Quote
Moggie Posted October 19, 2011 Report Posted October 19, 2011 [Here is the link for the manual - http://support.automation.siemens.com/WW/view/en/19397726 Section 5 gives details on errors etc Section 4 gives details of BASP Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.