CX-Programmer Mnemonics Addresses

[fluidflow]

In CX-Programmer, when looking at the Mnemonics is there a way to see the Addresses as compared to the symbol names? Example of what I get. ( ' PLC Battery Fault\nIf the low battery flag is on run the low battery timer. LD Is_Auto_Mode AND P_Low_Battery TIM 0154 #50 AND Low_Battery_Tmr ANDNOT Any_ShtDn_Alrm SET Battery_Flt) And what I would like to see. ( ' PLC Battery Fault\nIf the low battery flag is on run the low battery timer. LD H0.01 AND A402.04 TIM 0154 #50 AND T0154 ANDNOT W113.15 SET W83.06) Thanks 8-)

[Jay Anthony]

Not an elegant solution, but.... In Project Workspace, highlight the PLC and Copy. Highlight the project and Paste, Go to the new PLC and delete all symbols. The elements will revert back to their PLC addresses. I, too, wish we could view PLC addresses in Mnemonic view.