CJ1M CPU23 Error

[shairali]

Hi everyone, I am using PLC CJ1M CPU23 and error associated with PLC is that when I download program into it, program was successfully downloaded, but when I run the machine an alarm appears on the X-axis of NC413. When I use the PLC with another NC 413 the same alarm appears on NC Card, means to say that the error is of PLC not of NC413. Note that the PLC is installed on Vertical Packing Machine and x-axis of NC413 is for its Pull Belt assembly.  Kindly help me in resolving the issue.

 

Thanks

[Crossbow]

First, why did you post this under NJ Series / Sysmac Studio?  This is a CX-Programmer question.

Is the PLC program configured for the proper layout of the modules attached on the right side?