Iandb Posted February 23, 2018 Report Posted February 23, 2018 (edited) All, I have a customer asking me about a problem on their Omron screen. I'm sure that it is nothing to do with our programme on it more that they are trying to do something with the screen or even CPU outside of our programmes. The full message line I can see from the screen shot is: Date/time stamp (at start), HddBcupExec,Level???,Err=70, Permission denied The ??? are characters that I can not make out I have no knowledge of these but even to my untrained eye I guess that Hdd bit is essentially Hard Disk Drive, so they are trying to write to the disk? Customer reports " the fault was generated on panel first time yesterday and today too on first morning when turn-on the machine" Any help greatly appreciated. Edited February 23, 2018 by Iandb Quote
gclshortt Posted February 23, 2018 Report Posted February 23, 2018 http://www.edata.omron.com.au/eData/HMIs/NT/V020-E1-04.pdf Since the error does not appear in the manual, I would contact your OMRON service center. Regards, Garry Quote
Jay Anthony Posted February 23, 2018 Report Posted February 23, 2018 This sounds like a programmed alarm message not generated by the NT20S operating system. Get screen shot with camera, Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.