Analog In/out (CP1W-MAB221)

[Michael02]

Hey!

I am brand new to CX programmer, I have used sysmac studio and visilogic before. But i was wondering how to i set analog inputs and outputs to a specified variable. Have been searching around for quite some time now and cant seem to find it, most likely because everyone should already know it.?  (I am using a CP2E-N14DR-D PLC)

[gtsuport]

Please reference the W614 manual.

Section 17-4 shows how to configure these modules.

Section 17-7-2 shows wiring.

Hope this helps.

gtsuport