kevin-sw Posted May 16, 2006 Report Posted May 16, 2006 Dear All, I bought Twido PLC type TWDLCAE40DRF and XBT-PM027010 and connect them with cable XBTZ968 as recommended. But there are error messages reading and writing data table impossible. Is anybody could help me? Thanks, Kevin Quote
Kiwikev Posted May 22, 2006 Report Posted May 22, 2006 Hi Kevin Don't have much experience with this - but last week I replaced a Nano with a Twido that were connected to an older XBT and on boot up I got the same message - but once the PLC was running the message went away. So is the PLC in run mode? When I originally connected them together I got ERROR because the comms setting was incorrect - but the reading / writing must mean they are communicating. Hope this helps. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.