rogeliososa Posted September 6, 2006 Report Posted September 6, 2006 Hello, I am trying to link one HMI CTC from parker with a Koyo PLC DL205 cpu 260. The ctc has the driver: Siemens/koyo/205/305/405. I can configure this driver with the port, baud rate,etc. The PLC DL205 is using the protocol Ksequence and I am trying and trying changing baud rate, parity, etc. and I do not get sucess. Can somebody share me a technical tip???? thanks a lot. Quote
GerryM Posted September 7, 2006 Report Posted September 7, 2006 (edited) The only thing I can think of, without getting into details, is this: If you are using the programming port then connect your laptop to the koyo plc and using the programming software, from Automationdirect.com, try to connect to it. The software will search for the correct baud rate, etc. Once the setting are found use those settings in your HMI. Edited September 7, 2006 by GerryM Quote
Steve Bailey Posted September 20, 2006 Report Posted September 20, 2006 I'm betting that the CTC HMI is using the DirectNet protocol and not K Sequence. Try setting up the port on your DL205 for DirectNet. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.