Search the Community
Showing results for tags 'cp2'.
Found 2 results
-
Hi there! I'm trying to communicate a Weintek cMT2128X with a CP2EN via Ethernet. The thing is I'm getting 'No device response' messages every 2-3 seconds. They'are connected at some point because some values are updated, but the connection error keeps showing up. So far I've checked: - Comm. settings are okay in both sides - Wiring is good - Happens the same with a CJ2 CPU. - There are two arrays of 50 UINT each, I don't know if that's slowing things but that would surprise me... I've worked with Weintek HMIs before (communicating with different CPUs: LOGO!, CP1, CJ2...) and never had this problem. I just set the IP addresses and everything was working fine, so I guess I'm missing something. Hope you can throw some light at this! Thanks in advance
-
Hello, i am trying to get my connection between my 2 PLCs to work. (CP1H master -> CP2E-N slave). i had already read i need to jump my data areas from 3100 to 200. Below you can see that the CP2E (right) is receiving the signal and CP1H(left) is not receiving the signal. Am i doing something wrong here. I tried changing the PC link unit number to 0 because i was i doubt where i should start counting. Hope you guys can help me out here!
