Search the Community
Showing results for tags 'fatek'.
Found 7 results
-
Hi, I'm going to monitor my data by labview, I am using FUN150 to monitor R0 (for example) into labview as 400001, but the function in winproladder show error. I attach the winproladder programm
-
hy all. i am having an error while communicating with fatek plc. when i communicate it gives an error. " Com port open fail, plz check if this port is used by other programme when we online the PLC (Fatek/ WinProLadder). kindly Guide me as it looks like port is already used by another program . and i dont know how to kill that program ..
-
I am using fatek FBs 32MN PLC. i need to run the nema stepper motor synchronized with induction motor's speed with some ratio. in my case the speed of stepper motor will change as the speed of induction motor changes its speed, may be many times in a second. Problem is that the speed of stepper will be constant as before until i have to disable and then enable again HSPSO function. is there any solution that i can dynamically change the speed of stepper without disable and enable HSPSO function ?
-
hi there is a 1215c and a fatek B1 plc here. 1215c as master and fatek as slave. i want to read 10 16bit words from Fatek to 1215c and i use Modbus rtu 485. i have a problem with what comes from Fatek To 1215C. thx 2018-08-25_11-56-16.mp4
-
Hello, I need to build a project with PID function. The main objective is to work with pressure (sensor is 0-16bar 4-20mA). If pressure is between 5 and 7bar (7 is set point), I want PID to give scaled values at my analog output. Pressure <= 5bar = 100% Pressure > 5bar and < 7bar = scaled values Pressure >= 7bar = 0% So actually as I understand, I need need a second set point. The HIGH set point is 7. The LOW set point is 5. How am I going to give the low set point? Thanks in advance!!!
-
Hello everyone, I am completely new with Fatek PLC. Can somebody help me (example, tutorial, explanation) with a serial communication between Fatek and PC. I am using FBs series.
-
Dear @ s good afternoon! You see I have a small problem, scale the signal of the plc manually using equation of the line and other steps, so I did a PLC Delta, but I've spent time in a PLC FATEK and apparently see it is more advanced and there is another way to do it using its simulator "WinProladder" to achieve it. So the question is: Can you help on how to scale using functions WinProladder for FBs-24MC plc Fatek? regards
