Jump to content

Ramkumar

MrPLC Member
 View Profile  See their activity

  • Posts

    39

  • Joined

  • Last visited

Profile Information

  • Country
    India

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Ramkumar's Achievements

Contributor

Contributor (5/14)

  • First Post
  • Collaborator Rare
  • Week One Done
  • One Month Later
  • One Year In

Recent Badges

0

Reputation

  1. Ramkumar
    Please suggest, if the IP address of the PLC shall be set from the HMI.
  2. Ramkumar
    Hi Crossbow, thanks for the response. We wanted to know this, wince we wanted to disable the User authentication, if the HMI is under simulation. When the HMI is simulated , we are unable to login. The HMI used is GOT2000.
  3. Ramkumar
    Hi CrossBow, Thanks for the response. I`m looking for a register which will let me know that the system is under simulation.
  4. Ramkumar
    Oh, I wanted the simulation which is done through the GXWorks software. If it doesn`t have that, is it possible to read the simulation status from the GOT2000 HMI ?
  5. Ramkumar
    Hi All, Shall anybody look into this please... Thanks in advance, Ramkumar
  6. Ramkumar
    Hi, Please let me know if any special purpose register is available to know the status of Simulation, if the PLC is run in the simulation mode. Please let me know. Thanks in advance !
  7. Ramkumar started following Tight VNC HMI connection getting automatically disconnected , Simulation status of iQR PLC , GT Designer doesn`t login in Simulation mode and 1 other
  8. Ramkumar
    Hi, could anybody help on this request please...
  9. Ramkumar
    Hi, When I`m in simulation mode, I`m not able to login the HMI using the usual user details. Please let me know if there is any solution available for this issue. Regards, Ramkumar
  10. Ramkumar
    Thanks a lot for the response sir !
  11. Ramkumar
    Hi, please guide on this topic if someone has an idea...
  12. Ramkumar
    Hi VeeB, I set the "Guaranteed Time" to 60 seconds and expected the VNC connection to close. Waited for more than that time and the connection didn`t closed. Kindly advise on this.
  13. Ramkumar
    Hi VeeB, Thanks a lot for the response ! It was highly helpful. Please let me know of the disconnection shall be triggered from the HMI if we want to disconnect the VNC clients...?
  14. Ramkumar
    Hi, I would like to automatically close the VNC viewer connection, which is used to view the GOT2000 HMI remotely. Very interested to know if any options are available. Thanks in advance !!!
  15. Ramkumar
    Hi, The Tight VNC is disconnecting us automatically after minutes of operation. Could you advise us if there is any particular setting in the GT Works, which is controlling this... Thanks in advance.. Ramkumar
  16. Ramkumar
    Please find the attachd image of error
×
×
  • Create New...