Yuto24
-
Posts
20 -
Joined
-
Last visited
-
Days Won
1
Recent Profile Visitors
725 profile views
Yuto24's Achievements
-
Greetings Can someone tell me about a memory that saves the data even when the machine is turn off? I need one for a speed pulse for a driver and all the memorys that I used where not saving the data. The PLC is an FX3S-MT32
-
Also you can use a coil when the 5th timer is activated to have an interlock to m25 an reset the sequence, then an NC to cut the energy of the ladder
- 6 replies
-
- 1
-
-
- mitsubishi
- ton
- (and 3 more)
-
I have the card here, how can I turn on the amplifier to run the servo?
-
If you have different passwords levels the problem might be the security level of the screen, you need to mach the security level of the screen to the password level
-
Hi guys I need some help using the amplifier MR-J4W2-44B, im trying to connect it to a FX5U but I dont know were to send the output for the pulses for the amplifier, and the diagram doesnt show any servo ignition or pls-sign as other amplifiers that I used before this one. Thanks for reeding
-
Thanks a lot!
-
Thanks both for the advices
-
Greetings! How can I measure the current voltage of my 24V Battery using a FX5U, I need the PLC to turn on different outputs depending on how much charge is on the battery.
-
Greetings! I need some help. I want my timers have the 1ms speed so have a real time second counter, but I cant find the option on the GXWorks3. It's for a FX5U
-
The connection is made by half duplex mode, but when using the command to recieve data the values are 0 and verify that the data is acord to the coils from the slave, so I was suspecting that maybe the data went to another memory
-
Hi, I have the next question How can I use the M8000, H8192, or D8092 on my ladder programm, I know this devices are system special by the device but I need them cause a Modbus command needs it
-
Is there a way to verify the communication between the plc and the driver is ok?
-
How should I connect those pins to the Fx5U? I reed the diagrams examples but I cant resemble them to the PLC pins of the 485
-
https://www.roboteq.com/docman-list/motor-controllers-documents-and-files/documentation/datasheets/203-fbl23xx-datasheet/file That is the datasheet of the driver
-
Greetings I'm new in RS-485 protocol and I need to communicate a motor driver from Roboteq which is "FBL2360" whit a FX5U-32MR. I'm confused of how to get the proper connection and how to transfer data from the PLC to the driver