Jump to content

Stevepjr

MrPLC Member
  • Posts

    3
  • Joined

  • Last visited

Profile Information

  • Country
    United States

Stevepjr's Achievements

Newbie

Newbie (1/14)

  • First Post
  • Week One Done
  • One Month Later
  • Conversation Starter

Recent Badges

0

Reputation

  1. Thanks hecateh I'll try this next time I am on site.
  2. Thanks for the reply Crossbow. Is there a way to find this out? If I look at the size of each page they are set to 1280x800 (except for popups of course). And the size grayed out so i can't change any values. I'm assuming that is hard-set when you select your HMI.
  3. I have a customer that is requesting some HMI upgrades for one of their processes. I uploaded the project and made the changes i needed to, however i noticed something strange. When i would start the NA simulation, the lines (piping) i animated between tanks and pumps were way out of position. Within my project everything is square and level. I verified the page settings are set to 1280x800 on the original page and mine. I basically duplicated the HMI pages and made the changes i needed to. I tried running the simulator on a 1080 screen and 1440 but had the same effect. I finished the project and downloaded it at the customer sight assuming that it was probably just my laptop display causing the scaling issue. When i navigated to the page i made, i had the same scaling issue. I ended up moving my line animations way out of proportion so i could square up the running HMI. I also noticed on other untouched (original) display pages the same scaling problem existed. Its a NA5-15w101-V1 and on omrons site is a 1280x800 display. Has anyone seen this before and know a remedy? Or do i need to keep making adjustments to offset the scaling issue? Thanks!
×
×
  • Create New...