Vongphet.Douangmany

Dear Everyone, I would like to know how to connect PACTware to Profibus Instrument on the field. In my Plant we use Schneider Modicon M580 PLC module for Profibus namely PMEPXM0100. When I try to connect, it shows an error warning that cannot establish a connection. Can anyone advise me on what steps I should take? Best regards, Vongphet.

We ordered a new VSD ATV950D75N4 to replace VFD ATV71, so no experience ,When we configured ATV950D75N4 for all parameter to match with motor then configure communication parameter same as original with Modbus TCP network and IP address,It can be communication to SCADA but can't operate motor such as start/stop. And when we turn OFF power and ON, the communication type it change back to default "Ethernet IP" ,Then impact to our network, How to solve this problem ?Please guide me on this if anyone knows. Thank you very much, Vongphet.

Thanks cHud you gave me the link. very helpful Now I can show the full window.

I have to replace new monitor for monitor CitectSCADA but screen not display full window. The old monitor resolution is 1680x1050 and new monitor solution is 1920x1080, How to set CitectSCADA to display full window ? Best Regards, Vongphet

Dear all, PanelView Plus 1000 The touch screen not move when pressed and Show hands, do not touch, How to fix this cause. Regards, Vongphet Douangmany

You can't create Excel report for alarms during run time, you should create alarms first in Excel after finish save and close Excel, then compile Citect scada graphics if anything complete no alarms, you should backups project after that you should stop run time and restore new file from back up after restore finish then start run program again The alarm report should have.

Hi All, I have PanelView C300 Micro HMI. It is damaged no have spare part but have spare only Panelview C400, How to convert file from panel view C300 to panel view C400? How to download file from panel view C300 to panel view C400?

Dear all, Who can help me about configure Modbus soft starter model ATS48C59Y for Control motor, I don't know how to configure IP Address Mapping with PLC Unity Pro XL V11.0 If you know what I should do, please teach me. Thanks,

Dear all, I want someone help me about how to find IP address HMI of panel view plus 1000 or how to connect if we don't know IP address, Thanks ,

The red fault light .Is it on all the time not blinking

this is PLC for Wad Cyanide analyzers .

How to fix MicroLogix 1100 fault display not show please see Photo below .

How to upload for backup file of Panel view 1000 ?

Hi Quant Thanks for suggest, how to know what version DTM support with PLC Unity pro XL V11.0 could you suggest me some technique ?

Hi Quant Thanks. for introduce to me right now we can solve problem this alarms but I have new problem could you help me , when not connect with Endress+Hauser not alarms. if connect with Endress+Hauser alarms DTM Used in application is not install but we already install how to solve this problem ? see photo below