PaulKim1003

I had to reset the drive to default and re-program it. It is working fine now. Thanks for the help. @Chris Elston @ElectronGuru

Thank you guys! I will look into it.

Hi everyone, I have four PowerFlex 755 drives, and one of them is behaving oddly. Its command speed is stuck at 40Hz and doesn't respond as expected. I've already checked the Max Frequency (parameter 37) and Speed Reference Select (parameter 545), and both appear to be configured correctly. Has anyone encountered a similar issue before or have any suggestions on what else to check? Thanks in advance!

Hi Allen, Do you have another identical digital input card in a different slot that is currently working? if you do, swap it with the problematic one and see if the error persists.

Do you have any error ?

Thank you @BobLfoot

Hi @SSrikakolum, At the end of each rung, include an unlatch for your button. It will fix your problem :)

Hi, I am trying to automatically send an email via RSLogix 5000. I have already set up my msg instructions to configure the mail server and created a string tag for the email body. I can send an email to myself. I am just curious how I would go about adding the tag data in the message. Has anyone done this? Thanks

Hi, I have a few PowerFlex 400 drives and One of them is acting really weird. I set the speed setpoint to 13Hz but it can't go over 1 hz. It is beeping and it says it is accelerating in CCW but it is not going over 1 hz. It is like a sine wave. Going up and going down and continue doing this. I compared the parameters with the other powerflex 400's but it is identical.. I think it is an electrical problem but I just want to post it here to know if anyone had same issue before. Thanks Have a great weekend,

@SSrikakolum The data type is strings. Change the data type to string and see if it works.

Thank you guys!

@Mickey Thank you so much!

Hi, can someone help me with converting a .rss file to a pdf file? Thank you in advance ML1000_2024_01_07 - Copy.RSS

Hi, Is it possible to secure a program with a password? It is studio 5000 version 28.03. Thank you

Thank you for your replies. I appreciate it.

Thank you @Hati

Hi, I created a tag(paul) as dint. I have paul.%x0 and paul.%x1 and I can not modify them (to make them on/off) is it possible to enter a value into the monitor value? if possible, I would like to put 3 into the monitor value to make the paul bits ON.

Hi guys, Our automated equipment is using PILZ PLC and we are trying to replace it. Is there any other safety PLC that can be replaced for the PILZ PLC? Thanks

Thank you @ElectronGuru !

Hello, We replaced a motor so I decided to do the static auto tune by using CCW. When I clicked "Finish" button at the end, I got a message "Failed to write a new value message - This parameter is only editable on the Identity Page." Is it because I opened a project with using discovery option? Has anyone seen this error before? Any help would be appreciated. Thank you Sinamics(G120) - F7800.pdf

@BobLfoot @Joe E. I turned off the PLC and replaced the cable. Now I can go online with the PLC :) Thanks everyone who replied on this issue. This just made my day. Thanks again

@BobLfoot - Thank you Bob, I did it but no luck :( @Joe E. - Thank you Joe, I will replace the cable and post it here how it went.

Hello guys, I stopped and restarted RSLinx and found out something. The controller has the yellow question mark with a red X on it (unrecognized Device). I guess this is why it was not working. I can still ping the IP address. Thanks for the replies :)

@Joe E. - Yes It does show up @alan_505 - thanks for the reply

yes, I can see the processor in RSLinx. I never had this problem before.. Maybe I should connect my laptop to the processor to go online with it :(.